040-M Barcor Dial Hole Gage: .25-1mm
The Barcor 040-M dial hole gage has the following specifications:
The Barcor hole gage is a direct reading instrument designed to measure a small hole diameter. Barcor hole gages could not be any easier to use. The operator has to insert the gaging plunger into the hole, press the base firmly against the part and the diameter will be displayed on the dial.
Unlike most types of "bore gages", the Barcor hole gages do not require a setting master.
There is a "set to" number stamped on the back of each hole gage. The user just need to
press the base of the chamfer gage up against any flat surface and make sure the needle
is pointing to the "set to" number that is on the back of the dial. If the gage is slightly off, the
user can easily rotate the bezel of the gage until the needle is pointing to the "set to" number and then the hole gage is ready to use.
Barcor Dial Hole Gages - Metric:
Barcor Dial Hole Gages - Inch:
If you have a specific question about the Barcor 040-M Hole Gage, please contact our inside sales department and we would be happy to assist you.